Maintenance; General; Extension Cords; Lubrication - Craftsman 315.10411 Owner's Manual

MAINTENANCE
GENERAL
Only the parts shown on parts list, page eleven, are
Intended to be repaired or replaced by the customer_
All other parts represent an Important pad of the
double Insulation system and should be serviced on.,
ty by a qualified aervtce technician
Avoid using solvenla when cleaning pIasllc parts.
Most plastics are susceptible to various types of
commercial solvents and may be damaged by their
use Use clean cloths to remove did, carbon dust,
etc
When etectr$c toots are used On fiberglass boats,
sports cars, etc., it has been found that they are sub-
Ject to accelerated wear and possible premature
failure as the fiberglass chips and grlndlnga are
highly abrasive to bearings, brushes, commutator,
etc. Consequently 11Is not recommended that this
toot be used for extended work on any fiberglass
materiel. During any usa on fiberglass tt Is extremely
important that the tool is cleaned frequently by blow..
Ing with an air Jet. ALWAYS WEAR SAFETY' COG.
GLES OR SAFETY GLASSES WITH SIDE SHIELDS
BEFORE BEGINNING POWER TOOL OPERATION
OR BLOWING DUST.
EXTENSION CORDS
The use of any extension cord wtll cause some loss
of power_ To keep the toss to a mfntmum and to pro,
vent tool overheating, foIlow the recommended cord
sizes on the chart below. When tool Is used out,,
doors, use only extension cords sultabte for outdoor
Use and so marked, Extension cords are available at
Sears Catalog Order or Reiall Stores
Extension Cord Lenglh Wire Size AW.G.
25..50 Feet lB
50-75 Feet 16
75-100 Feet 14
LUBRICATION
All the bearings in this tooi are lubricated with a suf.
tlctent amount of high grade lubricant for the life of
the unit under normal operating condit!ons,
therefore, no further lubrication ls required
THE FOLLOWING RECOMMENDED ACCESSORIES ARE CURRENT AND WERE AVAILABLE AT THE TIME THiS
MANUAL WAS PRINTED..
High Speed Bits (For wood or metaI) 3/8" Max Drill Stand (9 25989)
Masonry Bits 1 t2" Max. Dowe_lng Jig {9 4186)
Wood Boring Bffs !-1t4' Max Cord Lock (9. 2595)
Hole Saws lq/2'" Max Chuck Key Holder (99 2978)
Hole Square (99 2595) Portallgn OrilI Guide (9 11227)
Carrying Case (9 1477} Wood Boring Pilot Set {9 2588)
The use of attachments or accessories not listed above might be hazardous
Page 9