Driving Belt - Chery Karry series User Manual

The depth of the tire tread wear
is illegally limited. After the
wear reaches the limit value of
3mm, there is a wear strip occurring on the
tire tread, which indicates that the
performance and safety of the tire reduce
considerably and the tire must be replaced.
Dispose the worn tire according to local
regulations on environmental protection.
Change the winter tire to summer tire as
soon as road condition permits, which can
reduce fuel consumption and lower the
noise
Replace the tire
The tire available for your vehicle is
properly selected to provide the best
operation, comfort and safety. The above
specifications on the tire-wheel rim
combination are suitable for the steel or
aluminum alloy wheel rim. To understand
whether the other kinds of tires and wheel
rims are used in this vehicle, please
contact the Chery's special service station.
If you want to install a
nonstandard tire or wheel
rim, (e.g., light alloy wheel
rim or wheel with winter tire),
comply with the related instructions
or contact the Chery's special service
station.
It is strongly recommended to use the
genuine tire when the tire is installed or to
refer to the recommendation from the
Chery's special service station.
The improper
wheel rim may result the
traffic accident, without the
warranty.
Caution:
The pedometer is affected
dimension of tire applicable for the vehicle.
If the tire dimension (diameter) is different
from that of the genuine tire, the exact
Repair & Maintenance
speed can't be displayed.

Driving belt

The driving belt is one of the parts subject
to the most severe stress. Therefore, the
belt must be of high quality and reliable to
meet with operational needs.
When the driving belt is replaced, it
cannot meet the requirement if the belt
with the same dimension is selected only.
For the sake of safety, please use the
Chery genuine belts only. The genuine
driving belts are available in the Chery's
special service station.
Caution:
The driving belt may somewhat extend
after it is in service for a certain time, and
tire and
the belt will be loose when the extension
reaches the limit, which may result the
fault and damage the vehicle. So, the
tension of generator belt shall be checked
after the vehicle travels 1,000 Km.
by the
Check the tension of driving belt
1. Turn off the ignition switch and take
out the key.
95