Setting Zone 2 Protocol - Bose Acoustimass-20 Owner's Manual

Figure 14 a
Setting Zone 2 Protocol
Setting
Zone 2 Protocol
For the Acoustimass 5 or 20 powered speaker system to work properly with a Lifestyld' media center,
you will need to check the Zone 2 Protocol to ensure that it is set to Normal mode (Figure 14 a).
1. While your Lifestyle system is on, press the Settings button on your remote control. This will open
the on-screen display.
2. Scroll down with the down-arrow button and select System Setup using the Enter button.
3. You will now see a menu entitled System Setup (1 of 3). Scroll down to "more...".
Continue to scroll down through (2 of 3) to (3 of 3). The last item on System Setup (3 of 3) is Zone 2
Protocol.
4. If necessary, use the right-arrow button to set the protocol from Legacy to Normal.
5. If you changed the Zone 2 Protocol, shut off the system and turn it on again; this ensures that the
Zone 2 Protocol is reset to Normal mode.
Connecting
power to your
system
,_ CAUTION: If you purchased a dual-voltage system, it is important that you set the speakers to the
correct voltage. To do this, refer to "Selecting the correct voltage" on page 6.
Follow these steps to connect power to your Acoustimass powered speaker system:
1. Plug the power cord from the Acoustimass module into an AC power (mains) outlet.
2. Insert the power cords of the Lifestyle _ system into an AC power (mains) outlet.
3. Turn the Acoustimass module power switch to the On position.
AM26283S O0 !Zpdf December 20, 2001 13