Bosch Vision 300 series Operating, Care And Installation Instructions Manual page 5

Clothes
Table of Contents

Advertisement

Available languages

Available languages

10. When children become old
enough to operate the appliance,
it is the responsibility of the parents
or legal guardians to ensure that
they are instructed in safe
practices by qualified persons.
11. Do not allow children to play on or
in the appliance at any time;
severe injury or death could result.
Children should be kept a safe
distance away from appliances at
all times. Children should only be
permitted within an appliance's
vicinity if under close, constant
adult supervision.
12. Do not allow children's toys or
other items that might encourage
children to climb on the washer, to
be stored on or in the washer or on
shelves or in cabinets or other
storage areas above the washer.
13. Do not sit or stand on the top of
the washing machine.
14. Do not allow anyone to climb, lean
or hang on any part of the washer
including any protruding
components such as the
appliance door or a pullout shelf.
15. To reduce the risk of poisoning or
chemical burns, keep all cleaning
products out of the reach of
children.
16. Keep pets away from the washing
machine.
17. Do not reach into the appliance if
the wash drum is moving.
18. Do not install or store this
appliance where it will be exposed
to the weather.
19. Do not tamper with the controls.
20. Do not repair or replace any part of
the appliance or attempt any
service unless specifically
recommended in the user
maintenance instructions or in
published user repair instructions
that you understand and have the
skills to carry out.
21. Do not touch the washer door if
washing at high temperatures.
22. Use caution when draining hot
water.
23. Removing any panel can expose
sharp edges and points, electrical
connections or hot surfaces.
24. Always unplug the washing
machine from the power supply
before attempting any service.
Disconnect the power cord by
grasping the plug, not the cord.
25. Do not machine wash fiberglass
materials (such as curtains and
window coverings that use
fiberglass materials). Small
particles may remain in the
washing machine and stick to
fabrics in subsequent wash loads
causing skin irritation.
26. Do not insert/pull out the power
plug with wet hands.
27. Do not use the washing machine if
it has a worn power cord or loose
plug. If this is the case, contact an
authorized service agent.
28. Do not operate the washing
machine if any guards, panels
and/or fasteners except transport
fixing bolts have been removed.
29. The washing machine must only
be used for its intended purpose.
30. Always follow the fabric care
instructions recommended by the
clothing manufacturer.
31. Make sure that all water
connections to the washing
machine have shut-off valve(s) that
are readily accessible. Close the
washing machine water shut-off
valve(s) at the end of each wash
day.
32. Check the fill hose connections on
a regular basis to ensure that they
are tight and not leaking, and
before applying power to the
machine.
33. Always read and follow the
instructions of the manufacturer of
the detergent(s), cleaning aid(s),
fabric softener(s) and static
eliminator(s) which you are using.
Heed all warnings and
precautions.
34. Do not operate the washing
machine if parts are missing
or broken.
35. Do not operate this washing
machine until you are sure that:
a.
the washing machine has
been installed according to
the INSTALLATION
INSTRUCTIONS.
b.
all water, drain, power and
grounding connections are in
compliance with all local
regulations and/or other
applicable regulations and
requirements.
36. Failure to install, maintain and/or
operate the washing machine
according to the manufacturer's
instructions may result in injury
and/or damage.
37. To avoid damage to the door, do
not push against the door when
moving the unit. Precautions
should be taken to avoid damage
to the floor as well.
38. To avoid floor damage and mold
growth, do not let spills or
splashes cause standing water
around or under the appliance.
39. The water connections should be
made and tested before electrical
power is applied to the machine.
SAVE THESE
INSTRUCTIONS

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vision dlx seriesVision 500 series

Table of Contents