Bosch Vision 300 series Operating, Care And Installation Instructions Manual page 15

Connecting the Power Supply
Improper connection of the equipment grounding
conductor may result in electric shock. Have the
appliance checked by a qualified technician or
licensed electrician if you are in doubt as to
whether the dryer has been properly grounded,
(4 wire)
Do not plug the end of the
power cord into a live
receptacle before connecting
power cord to appliance
terminals and closing the
junction/splitter box as
described below.
terminal bmock
grounding strap
bracket for
_1__
strain relief clamp
Q emove the two screws from the terminal block cover
located at the top rear of the
appliance. This will expose
the terminal block assembly.
_._!_!ii_i_i_]i_i_i_i_i_ii_!i!;!_!i_!i_!i_!_!i!i_i_ii!_!i!_i!i_!_i!i_iiiiiii_iii!_!iii_iii_ii_ii_ii_i_!i!_i!_!_ _ii l o . _
Loosen the bottom
screw of the grounding
strap. Straighten the
grounding strap so it is
vertical. Replace the
green screw in the
GROUND terminal hole. ........
_] Make sure the grounding
@
strap does not touch the
back panel to avoid
tripping the circuit breaker
during dryer operation,
Fix a strain relief
clamp (available
from an electrical or
building supply
outlet) to the angle
bracket. Tighten the
nut to firmly fix the •
clamp in place,
Q Loosen the 2
screws
labeled L and the
single screw labeled
N on the terminal
block. Also loosen
the screw on the
GROUND terminal.
Continued on the next page
15