Solving Problems Setting Up The Printer Or Installing Software - Epson Stylus Photo 785EPX Printer Basics Manual

Solving Problems Setting Up the
Printer or Installing Software
The printer makes noise after ink cartridge installation.
The first time you install ink cartridges, the printer must charge its
print head for about two minutes. Wait until charging finishes (the
green
Processing
or it may charge improperly and use excess ink the next time you turn
it on.
If the printer stops moving or making noise, but the green
light is still flashing after 5 minutes, turn off the printer.
Processing
If the light is still flashing when you turn it back on, contact EPSON
as described on page 91.
Make sure the ink cartridge clamps are locked down completely and
no packing material remains in the printer. Turn off the printer, wait a
moment, then turn it back on to clear the error.
You're having problems installing the printer software.
Make sure your printer is turned on and the printer cable is securely
connected at both ends. Then carefully follow the installation
instructions on the Start Here sheet. Also make sure your system meets
the requirements beginning on page 93.
Close your other programs, including any screen savers and virus
protection software, and install again.
If your printer icon (
Chooser, you may have too many items in the Chooser. Delete any
unused items and check the Chooser again.
For Windows Me, if you see a message stating that this version of
Windows is not supported, click
your printer will operate correctly.
For Windows 2000, if you see an error message or your software
doesn't install correctly, you may not have software installation
privileges. Contact your System Administrator.
For Windows 2000, if you see a Digital Signature Not Found screen,
click to continue with the installation. Otherwise your driver
Yes
installation won't be completed.
light stops flashing) before you turn off the printer
) doesn't appear in the Macintosh
SP 785EPX
. Your software will install and
OK
79