Epson Stylus Photo 960 Basic Manual page 41

6. Install the roll paper holders on
the printer.
Insert the left holder into the far
left slot, then insert the other
holder into the appropriate slot
on the right (either the 4-inch
slot as shown, or the 8.3-inch
slot further on the right).
7. Pull out approximately 15
inches of paper and insert it
into the roll paper feeder. Then
slide the edge guide snugly
against the paper.
Caution: Don't load roll
paper into the sheet feeder at
the top of the printer.
8. Push the paper into the roll
paper feeder as far as it will go
(about 10 inches). Hold the
paper in place for a few seconds,
until the printer feeds it automatically.
9. To verify that the paper is loaded straight, open the printer cover and look into
the printer.
Don't load roll paper in the cut
sheet feeder
Printing on Roll Paper, CDs, DVDs, and Card Stock
Roll paper feeder
35