Epson Stylus Photo 960 Start Here

EPSON Stylus ® Photo 960
Start
Start
Here
Here
1
1
Unpack
Unpack
1
Remove everything from the box.
Printer Basics
7 Ink cartridges
Paper
support
Printer
Roll paper
holders
Basket for
cut photos
Automatic roll
Front sheet feeder
paper cutter
2
Remove all the blue tape and packing materials inside and around the printer.
2
2
Attach the
Attach the
Paper Support
Paper Support
Insert the paper support into its slots
above the sheet feeder.
(To install the roll paper holders and
automatic roll paper cutter and basket,
see your Printer Basics book.)
3
3
Connect the Printer
Connect the Printer
Connection cables are not included with your printer. You need only one of the following cables:
• USB cable (PC and Mac
• Parallel cable (PC only)
USB Cable Users (PC and Mac)
1
Shut down your computer. In Windows
or Turn Off option.
Leave your computer turned off until section 7.
2
Plug the square
3
CPD-14810R1 Plug the flat
(You can use any open USB port.)
Printer Software
CD-ROM
Power cord
Print position
check disk
Parallel Cable Users (PC only)
Mini-CD ring
1
Shut down your computer. Click Start and select your Shut Down or Turn Off option.
Leave your computer turned off until section 7.
2
Plug the end of the cable with the slotted connector into your printer's parallel port,
CD tray
then secure it with the wire clips.
3
Plug the other end of the cable into your computer's parallel port and secure it
with the screws.
® ) or
, click Start and select your Shut Down
®
end of the cable into your printer's USB port until it stops.
end of the cable into your computer's USB port until it stops.
Square end Flat end
Slotted end End with screws
4
4
Turn On the Printer
Turn On the Printer
1
Connect the power cord that came with your printer to the printer's AC inlet.
2
Plug the other end of the power cord into a grounded electrical outlet.
3
Press and release the power button to turn it on.
Power button
CAUTION: Never use an external switch, such as a wall switch
or power strip switch, to turn the printer on or off.
5
5
Install Ink Cartridges
Install Ink Cartridges
1
Open the output tray and the printer cover. Then open the cartridge cover and
remove the protective sheet.
2
Remove the ink cartridges from
their packages. Don't remove or
tear the blue labels from their sides.
3
Slide each cartridge individually into its slot with the green part facing the back.
Then push each one down until it clicks into place.
Make sure the colored circles match.
4
Close the cartridge cover and printer cover.
5
Press the ink button.
Ink button
The green power and red ink
lights flash as your printer charges ink
for about 1 1 / minutes.
2
CAUTION: Don't turn off the printer
or interrupt charging, or you'll waste
ink. If the power and ink lights
don't turn off after 5 minutes, and
the printer isn't making any noise,
you can turn it off.
Turn over
Don't touch the green part.