Paper Replacement - Woodstock SHOP FOX W1773 Owner's Manual

37" drum sander
Table of Contents

Advertisement

Paper Replacement

The Model W1772/W1773 is designed for 6" wide sandpa-
per rolls.
To change the paper, do these steps:
1. DISCONNECT POWER TO THE SANDER!
2. Lift the top cover and place a screwdriver through
the right side of the frame, as shown in Figure 29.
3. Rotate the sanding drum to stretch the tension
spring. Fit the end of the spring tension tool shaft
through the hole in the tension wheel arm (see
Figure 29) and into the head of the cap screw secur-
ing the spring.
4. Remove the screwdriver.
5. Repeat Steps 2–4 on the opposite end of the sanding
drum, then remove the spring clips. Note: Replace
the paper on each drum individually. Once the
paper is removed the drums can be slippery and
hard to rotate.
6. Unwind the old sandpaper and use it as a pattern, or
use the pattern in Figure 30 to cut the sandpaper to
the necessary shape, or see Figure 31 if using a dif-
ferent width of sandpaper.
7. Start with the left side of the drum, fold the corner
of the sandpaper into the spring clip, then install
the clip onto the tension wheel. Tap the clip with a
hammer or mallet to ensure it is seated. Note: DO
NOT pound the clip over the sandpaper. It is not
necessary to drive the clip completely on, just make
sure it is secure. Too much force will break the clip!
8. Tightly spiral the paper onto the drum, ensuring
there are no bubbles or overlapping edges, leaving a
uniform
/
" gap between the spirals as you wind the
3
16
paper around the drum.
9. Fold the corner of the loose end into the spring clip,
then install the clip onto the right tension wheel.
10. Remove the spring tension tool from the ends of the
sanding drum to tension the paper, and repeat Steps
2–10 for the other drum.
W1772/W1773 37" Drum Sander
Turn to SECTION 5: ACCESSORIES on
Page 29 for grit selection and model
numbers.
Tension
Tool
Phillips
Screwdriver
Figure 29. Locking the tension wheel.
��
���
Figure 30. Sandpaper pattern.
����
��������������
Figure 31. Finding sandpaper taper angle.
-28-
NOTICE
Spring Cap Screw
���
����
������������
���������
��������������
�����������
OFF

Advertisement

Table of Contents
loading

This manual is also suitable for:

Shop fox w1772

Table of Contents