Woodstock SHOP FOX W1773 Owner's Manual page 18

7. Remove the bolts, flat washers, and hex nuts from the
control panel support arm, as shown in Figure 10.
8. Remove the right access panel.
9.
With assistance, lift the control panel into place and
secure it with the bolts, flat washers, and hex nuts
removed in Step 7.
10. Reinstall the right access panel.
11. Attach the brace from the control panel to the sander
as shown in Figure 11.
12. Place the handwheel over the shaft shown in Figure 12
and tighten the set screw in the handwheel hub.
W1772/W1773 37" Drum Sander
Figure 10. Control panel mounting bolts.
Figure 11. Control panel brace.
Figure 12. Handwheel installed.
-16-