JVC DD-8 Instructions Manual page 18

Preparation (continued)
3
Press 2 or 3 to select the video
signal type suitable for the TV.
• When the TV is connected to the [VIDEO]
terminal or the [S-VIDEO] terminal, the
video signal type can be selected as
instructed below.
- Select "480I" for a TV only compatible with
interlaced video siginal.
- Select "480P" for a TV equipped with a
component terminal and compatible with
progressive video signal.
• When the TV is connected to the [HDMI] ter-
minal, the video signal type can be selected
as instructed below.
- Select "AUTO" for normal usage (the initial
setting).
- Select "480P" or "720P" as needed.
NOTE
• "480" and "720" refer to the number of the scan-
ning lines. Generally, the larger the number, the
better picture that can be obtained.
• "I" refers to the interlaced format. "P" refers to
the progressive format. A better picture can be
obtained in the progressive format than in the
interlaced format.
• When an HDMI video signal is output, the
"HDMI" indicator lights up in the display window.
• When an HD video signal (720p) is output, the
"HD" indicator lights up.
• When "480P" or "720P" is selected, the "PRO-
GRESSIVE" indicator lights up in the display
window.
4
Press [ENTER].
• The selected video signal type is displayed
in the display window for a short time.
13
Do not turn on the power until
you complete the connection.
NOTE
• The picture may be distorted when you press
[ENTER], but this is not a malfunction of the sys-
tem.
• To check the compatibility of your TV, contact
your local JVC customer service center.
• All JVC-manufactured progressive TVs and
high-definition TVs are fully compatible with this
system.
• Even if the main unit is turned off, the video sig-
nal type setting is stored.
Selecting the monitor out type
To view an image on the TV, select the monitor out
type as well as the video signal type.
1
2
3
4
For the locations of the remote
control buttons, refer to page 12.
Press [SETTING].
Press 5 or / to display "M.OUT".
Press 2 or 3 to select "HDMI" or
"NO HDMI".
• When using an HDMI cable to connect a TV
to the main unit, select "HDMI".
• When an HDMI cable is not connected,
select "NO HDMI" (the initial setting).
Press [ENTER] or wait for a short
time.