Selecting The Video Signal Type - JVC DD-8 Instructions Manual

NOTE
• This system supports up to HDMI version 1.0.
The HDMI video signal type can be checked with
the "HDMI" indicator in the display window.
(Refer to "Selecting the video signal type" shown
on the right.)
• If the picture is distorted while an HDMI TV is
connected, turn off the main unit and turn it on
again.
• A TV compatible with HDCP (High-Bandwidth
Digital Content Protection) can also be con-
nected to the [HDMI] terminal, so that the
uncompressed HD video signal type can be out-
put as well.
■ CAUTION
• Do not connect an S-video cable and a compo-
nent video cable at the same time. Otherwise
the picture may not be played back properly.
• Connect the main unit directly to a TV (or a mon-
itor) without routing through a video cassette
recorder (VCR). Otherwise picture distortion
may occur during playback. (Routing the con-
nection through a VCR, however, does not affect
the audio quality.)
Main unit
Direct connection
• Connecting the main unit to a VCR-built-in-TV
may also cause picture distortion during play-
back.
TV
(or monitor)
VCR

Selecting the video signal type

To view an image on the TV screen, select the
video signal type correctly according to the TV
after connecting the main unit to the TV.
1
Turn on the main unit. (Refer to
"Connecting the power cable" on
page 15 and "Turning on the main
unit" on page 16.)
2
Hold down [SCAN MODE] for 2 or
more seconds.
• The current video signal type flashes.
Example:
(Continued on the next page)
12