Advertisement
If, after following
the steps in tile chart
below,
the problem
still exists, ))lease cr)nsuh your
nearest IVC dealer.
etc.) might
i)revent
it from functioning
properly.
In sucln cases, first disconnect
its power
supply
unit (battery
pacl<, AC Power Adapter/Battery
Charger,
etc.) and wait
a few rninutes;
and then re-crlnnect
it and i)roceed
as usual from the beginning.
1.
No power
is supplied.
1.
2.
"SET DATE/TIME!"
appears.
Recording cannot be
i:lerformed.
1.
* Tile power
is not connected
properly.
• The battery is dead.
• The LCD monitor
is not open
fully or the viewfinder
is not
pulled out when recording.
8,
9.
In the 5-Second
mode,
recording
ends before
5 seconds have elapsed.
• The built-in
clocl<'s recharge-
able lithium
battery is
discharged.
• The previously
set date/time
is
erased.
3.
• The tape's erase protection
switch
is set to "SAVE".
The Power Switch is set to
• "TAPE END" appears.
• The cassette's cover is open.
,_Connect
the AC Power
Adapter/Charger
securely
(*_:_" p g. 11 ).
° Replace the dead battery with
a fully charged one
(L _ pg. 10, 1 I ).
° Open the LCD n/onitor
fully
or pull out the viewfinder.
The
LCD monitor
turns on/off
when
it is opened/dosed
at
approx. 90 ° while the Power
Switch is set to any position
except "OFF"
if the viewfinder
is not fully pulled out.
Connect
tile eameorder
to an
AC outlet
using the AC Power
Adapter/Charger
for over 24
hours to charge the clock's
lithium
battery (;L_" pg. 13).
Set the tape's erase protection
switch to "REC" (LS pg. 14).
Set the Power Switch to any
position
except "_"
or
"OFF" (L #" pg. 19).
Replace with new cassette
_
pg. 14).
Close the cassette's cover.
4.
There is no picture.
4.
• The camcorder
is not getting
4.
. Turn the camcorder's
power
rlower, or some other
off and on again {L_" pg. 20).
malfunction
exists.
5.
Some functions
are not
5.
• The Operation
Switch is set to
5.
° Set the Operation
Switch to
available
using MENU/SET.
"[]
".
"_]"
(iL_" pg. 19).
6.
The focus does not adjust
6.
• Focus is set to "MANUAL".
6.
. Set Focus to "AUTO"
automatically.
• The recording
was done in a
(L _ pg. 47).
dark place, or the contrast
. Clean the lens and check the
was low.
focus again {L_" pg. 98).
• The lens is dirty or covered
with condensation.
7.
The cassette will not load
7.
• The cassette is in the wrong
7.
. Set it in the right position
properly,
position.
(_/_"pg. 14).
• The battery's charge is low.
° Install a fully charged battery
(iL_" pg. 10, 1 I ).
The MultiMediaCard
will not
8.
,_Set it in the right position
load properly.
(iL_" pg. 16).
8.
,, The MultiMediaCard
is in the
wrong position.
9.
* The 5-Second
mode in the
System Menu is set to
"ANIM.".
9.
° Select "5S" or "5SD"
in the
System Menu
(iL_" pg. 3t_
39).
Advertisement
