Advertisement
Date/Time
Menu Explanations
iNDiCATiON
ON SCREEN
DISPLAY
OFF
ON
OFF
Makes all the indications
aprlear in the carncorder
(u" T pg. 29).
Keeps all the indications
(except the tape rurlning indicator,
warnings,
etc.) from
appearing
in the carncorder
(;c_ pg. 29).
Keeps the carncorder's
display
from appearing
on the connected
TV screen.
Makes the carncorder's
display appear on screen when the camcorder
is
connected
to a TV.
Makes the date/time
settings appear in the carncorder
(;c_ pg. 28).
Keeps the date/time
settings from aprlearing
in the carncorder.
DATE/TIME
Allows
yOLI to set the current date and time ¢ y pg. 13).
System Menu Explanations
TELE
MACRO
ON
Usually the distance to a subject where the lens is in focus depends on the zoom
magnification.
Unless there is a distance more than 1 rn (3.3 ft.) to the subject, the
lens is out of focus at the maximum
telephoto
setting. When set to "ON',
you can
shoot a subject as large as possible at a distance of approx. 60 cm (2 ft.).
* Depending
on the zoom position,
the lens may go OLIt of focus.
SCENE
_Tpg. 30.
BEEP/TALLY
WIND CUT
SOUND MODE
[DNUMBER
REC SELECT
5SO
_ T pg. 30.
ANIM.
Allows you to record a 1/3-second
clip. By using an inanimate
object and
changing
its position
between
shots, you can record the subject as though
it is
moving
(_ _ pg. 30).
The tally lamp comes on to signal the start of recording.
The beep sounds when the power is turned on or off, and at the beginning and end of
recording.
Also to activate the shutter sound effect (_ y pg. 25, 33).
OFF
The tally lamp remains off at all times.
Even though not heard while
shooting,
shutter sound is recorded
on the tape.
Disengages
the function
which
cuts down on noise created by wind.
ON
Helps cut down on noise created by wind.
="_%
" appears.
The quality of the sourld will change. This is normal.
Enables recording
of stereo sound on four separate channels,
and is
recommenr]ed
for use when performing
audio dubbing.
48 kHz
Enables recording
of stereo sound on two separate channels.
This number
is necessary when connecting
the camcorder
to a device such as a computer
using the J terminal
(JLIP). The numbers
range from 01 to 99. Factory setting is 06.
When Snapshot recording
is ilerforrned
with the Power Switch set to "_",
still images are recorded
only onto the talle.
TAPE
When Snapshot recording
is ilerforrned
with the Power Switch set to "_
",
&
still images are recorded
not only onto the tape but also in the MultiMediaCard.
CARD
DEMO.
MODE
Automatic
demonstration
will not take place.
ON
Demonstrates
certain functions
such as Program AE with special effects, etc.,
and can be used to confirm
how these functions
operate. When
"DEMO.
MODE"
is set to "ON"
and the Recording Menu is closed, demonstration
starts.
NOTES:
• tf a tape is in the c_mc_rde_i the demonstratk_r_ cann_t be turned _m.
• By turning off the camcorder,
"DFM().
MODE"
is set to "OFF" automatical/y.
: Factory-preset
Advertisement
