JVC GZ-HD7U Instructions Manual page 78

Hd hard disk camcorder
Hide thumbs Also See for GZ-HD7U:
Table of Contents

Advertisement

Warning Indications
• Displays the remaining
battery power.
High
Exhausted
• As the battery power comes close to nil, the battery
indicator
blinks. When the battery power is exhausted,
power turns off automatically.
• Appears when the date/time is not set.
17
• The built-in clock's rechargeable
lithium battery is
16
discharged,
so the previously
set date/time
is erased.
Connect the camera to an AC outlet using the AC adapter
for over 24 hours to charge the clock's lithium battery. Then
set the date/time.
• Appears for 5 seconds after power is turned on in recording
mode if the lens cover is closed or when it is dark,
• Remove the card once and insert it again. At this time
switch the camera's power on after inserting the SD card. If
the error is not cancelled,
replace the card with one that has
been guaranteed
for correct operation,
• Perform clean up to restore the capacity of the recording media.
• Appears when you attempt recording when the write/erase
protection
tab on the SD card is set to the "LOCK" position.
• The video management
file is broken. Recovery
is required
to record or play back video files, Move the set lever to ^ /
v to select [YES], then press down to recover the video
management
file.
19
72
38
ii_iiiiii%i_ii_ii_ii_ii_;iiiiii!iiiii_i_iiiiiiiii_iiiil
i_i_i_!_!!i!i_i!ii!ii!ii!ii!ii!iiiiiiiii_iii_iiiiii_iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii_i_i_iii!_!_i_!!!!_!ii!_i!i_!!i!i_iiiii!
• Appears when the event information
cannot be read.
• The writing speed of recording
medium is slow. or the
19
recording medium is corrupted.
Use an SD card that is
guaranteed
to operate.
• The recording medium was subjected
to vibrations
or jolts.
Be careful not to subject the recording medium to vibrations
or jolts.
• Appears when the recording medium is full and recording
38
is not possible. Delete unnecessary
files, or replace the SD
card.
• Appears when an incompatible
USB device is connected
to
the camera.
• Appears when a DVD burner that is switched off is
connected.
If you want to use the DVD burner, switch the
power on.
78

Advertisement

Table of Contents
loading

Table of Contents