Table of Contents
Advertisement
File Backup on the PC-Windows®(Continued)
Preparation:
Set the camera's power/mode switch to OFF.
USB Connector
DC Connector
USB Cable
USB Connector
_!
AC Adapter
To AC Outlet
• When you have finished operation
Always follow the procedures below when
disconnecting the camera, or turning off the
camera/computer power.
Failing to de so may cause damage to the
camera and computer.
1) Confirm that the access/charge lamp on
the camera does not light or blink.
(If the access/charge lamp lights or
blinks, wait until it is turned off before
proceeding.)
2) Double-click the [Safely Remove
Hardware] or [Unplug or Eject Hardware]
icon in the status bar.
3) Select [USB Mass Storage Device] or
[USB Disk], and then click [Stop].
4) Click [OK].
5) Disconnect the USB cable.
6) Turn off the camera and PC.
I _[o_l i _-']
oWhen
the USB cable is connected,
turning
on or off the camera
causes
malfunctions
of
the PC.
• Connect
the camera
directly to the PC, not
through
the hub.
• Do not use an extension
USB cable.
• Saving
the wrong
kinds of files in a
recording
medium
or deleting
files or
folders from a recording
medium
can cause
problems
with the operation
of the camera.
When
it is necessary
to delete a file from
a recording
medium,
delete
it through
the
camera.
Also, do not move or rename
folders and files in the medium
on PC.
• Never disconnect
the USB cable while the
access/charge
lamp on the camera
lights or
blinks.
56
Advertisement
Table of Contents
