Table of Contents
Advertisement
Troubleshooting
The camera
is a microcomputer-controlled
device.
External
noise and interference
(from
a TV, a radio, etc.) might prevent
it from
functioning
properly.
The following
phenomena
are not
malfunctions.
• The camera
heats up when it is used for a
long time.
• The battery
heats up during
charging.
• When
playing
back a video file, the
image stops momentarily
or the sound
is
interrupted
at junctions
between
scenes.
• To solve the problem,
first follow the
instructions
below.
• If the problem
is not solved,
reset the
camera.
(_
below)
• If the problem
persists,
please
consult
your
nearest JVC dealer.
• To reset the camera
1) Set the power/mode switch to OFF and
remove the power supply (battery pack
or AC adapter) from the camera, then
reattach it.
2) Execute [PRESET] from the menu.
(_ pg. 70)
• Connect the AC adapter securely.
16
• Detach the battery pack once again and re-attach
it firmly.
16
• Replace the dead battery with a fully charged one.
• If the camera is not operated for 5 minutes while the
power is on. it turns itself off automatically
to conserve
power. To turn the camera on again when using the
battery pack. set the power/mode
switch to OFF. then to
STANDBY/ON
When using the AC adapter, perform any
operation such as zooming.
• Adjust the brightness
of the LCD monitor or viewfinder.
70
• When using the viewfinder,
the LCD monitor is opened.
71
Either close the LCD monitor, or set the ]PRIORITY
SETTING]
to [FINDER].
• Move to a place where no vibration or excessive sound.
• The drop detection function operated. Set the power/
70
mode switch to OFF, and to STANDBY/ON
again. To turn
off this function,
set [DROP DETECTION]
to [OFF].
• Fully charge the battery, and then run it down. If the
16
problem persists, the battery is worn out and needs to be
replaced.
Please purchase
a new one.
• Make sure to use the camera under appropriate
operating
temperatures.
• The battery is worn out and needs to be replaced. Please
purchase
a new one.
8O
• Charging is difficult in places subject to extremely
high/low temperatures.
To protect the battery, it is
recommended
to charge it in places with a temperature
of 10°C to 35°C (50°F to 95°F).
• When the battery is already fully charged, the lamp does
not light. Check the remaining
battery power.
18
74
Advertisement
Table of Contents
