Sanyo WXU700 - WXGA LCD Projector Owner's Manual page 29

4. Select "Network setting" in the Network menu and press SELECT button, and then the LAN setting
screen will appear and selected LAN settings will be displayed. Adjust each item to the setting
environment. Consult your system administrator about the detailed settings.
Move among the items with the Point ed buttons and press SELECT button, move among the
columns with Point 7 8 buttons, adjust the figures with Point ed buttons, and then press SELECT
button to set.
5. After completing all the settings, select "Set" and press SELECT button. Now, all procedures have been
done. To cancel the adjusted settings, select "Cancel" and press SELECT button.
To confirm whether the settings are correct, follow the procedures described from the next page.
You can confirm the LAN settings you have made from "Network Information" (p.32). In such cases
that the LAN cannot be connected, see this screen.
DHCP: On
Item Description
DHCP .......................... Sets DHCP function On or Off. When you setup the network setting manually, select "Off".
When it is set On, IP address, Subnet, Gateway and DNS are automatically set according to your
network environment *
IP address .................Sets IP address of the projector
Subnet .......................Sets Subnet mask. Normally sets 255.255.255.0
Gateway* .................Sets IP address of the default gateway (Router)
2
DNS* .......................... Sets IP address of the DNS server.
3
*1 Set "On" only when the DHCP server is available on your network environment.
*2 Set [255.255.255.255] if the network does not provide the gateway (router).
*3 Set [255.255.255.255] if you do not use the function E-mail alert.
* While the network communication function (p.96) or moderator function (p.105) is to be executing, the menus
"Network capture", "Network viewer" and "Memory viewer" are displayed in gray.
Network setting
DHCP: Off
.
1
Network environment setting