Settings Before Using The Network Communication - Sanyo WXU700 - WXGA LCD Projector Owner's Manual

PC1
* The Main PC is a computer which started using communication function, and serves own
computer screen captured image to the Sub PC. The Main PC has an authority to quit using whole
communication. To become the Main PC, execute the command "Start Communication" or "Capture
transfer". For further information, see item "How to use the Network Communication". (+p.100)
* The Sub PC is a computer which receives a captured image from the Main PC. On the communication
mode, the Sub PC can become the Main PC.

Settings before using the Network Communication

To use the Network Communication, the capture setting of the
projector must be set either [1] or [2] as described below.
[1] Projector searches all the available subject computers in
the network automatically.
[2] Subject computers are registered to the projector.
Perform capture setting following to the description below.
[1] When serving the capture data to all the sub-
ject computers in the network.
By using the web browser, display "Communication Setting" from
menu "Network"-"Capture"-"Page 2". Confirm that the item Auto
search subject PC is "ON". If "OFF", change mode to "ON".
* Projector can find up to 30 computers in the network.
[] When serving the capture data to the specific
subject computers in the network.
Set the item Auto search subject PC "OFF" described in the
above and then display "Connection Setting" from menu
"Network"-"Capture"-"Page 3" with the web browser. Enter the
IP address of subject computer and click Set button to register.
* Up to 30 computers can be registered to the projector.
To display the served capture data, the software Network Capture 5 must be installed on the computer.
✐
Capture
PC2
PC5
Using the Network Communication
PJ1
PC6
Capture a screen
image of PC5 and
make marking with
a tool.