Kyocera KM-C830D Operation Manual page 8

1 Printer key
Press this key when you want to switch to the printer mode.
2 Copier key
Press this key when you want to switch to the copier mode.
3 Enter key
Press this key when you want to register a setting.
4 M (Cursor) key
Press this key when you want to scroll up among the various
functions, settings, etc.
5 N (Cursor) key
Press this key when you want to scroll down among the various
functions, settings, etc.
6 O (Cursor left) key
Press this key when you want to scroll left during a setting
procedure.
7 P (Cursor right) key
Press this key when you want to scroll right during a setting
procedure.
8 Numeric keys
Press these keys when you want to enter a desired value directly.
9 Stop/Clear key
Press this key when you want to cancel a setting midway through
it.
0 Message display
Indicates the status of the printer as well as other settings.
! Printer Ready indicator
Indicates the status of the printer.
Lit: Printing is possible. (The printer is on-line.)
Blinking: A recoverable error has occurred or the printer is starting
up (during self-diagnosis).
Out: The printer is off-line.
@ Printer Data indicator
Indicates the status of data reception in the printer.
Lit: Data is being processed or memory is being accessed.
Blinking: The printer is receiving data.
# Printer Attention indicator
Indicates a printing error. When this indicator is lit or blinking,
press the Printer key and check the message that appears in the
message display.
Lit: A printing error has occurred. (Refer to "3-2 When an error
messages appears..." on page 9 and resolve the problem.
Blinking: The printer is starting up, or requires operator attention
such as formatting of the Memory Card, etc.
G The message display in the printer mode
To enter the printer mode, press the Printer key. The message
display will change to the corresponding display for the printer
mode.
$ "GO" command
Select this command when you want to start printing, as well as
when you want to initiate the operation for form feed. This
command is also used to switch the printer on- and off-line. When
the printer is on-line, the Printer Ready indicator will be lit.
% "CANCEL" command
Select this command when you want to stop printing or you want
to clear an error message.
^ "MENU" command
Select this command when you want to change the printer default
settings.
1. Preparations
3