Check Print Quality; Remove Printout - Epson PowerLite 4100 Operator's Manual

E

Check Print Quality.

Make sure the ON LINE indicator is lit (Page 8) and the operator
access door is closed, and then send a file from the host computer
to the printer:
If the print is too light or too dark (smudged), or if some dots are
not being printed, adjust the printhead gap. (See "Adjusting the
Printhead Gap," Page 27.) If necessary, replace an old ribbon
cartridge with a new one (Page 99).
If desired, switch between near letter quality (NLQ) and draft
quality by pressing and holding ON LINE and then momentarily
pressing NLQ. Although NLQ has more dots, and therefore
looks better than draft quality print, draft is faster.
F

Remove Printout.

1. Press ON LINE to place printer off line.
2. Use FORM FEED to move paper to a convenient tear-off point.
3. Separate printout from paper supply at perforation.
4. Press ON LINE again to place printer on line.
Operator's Guide 5