Epson PowerLite 4100 Operator's Manual page 235

ESC S
ASCII: ESC S
Control: [ S
CTRL
Decimal: 27 83
Hexadecimal: 1B 53
Prints characters following this control command as subscript or
superscript characters. n specifies which is selected as follows:
n = 1 or 49: Select subscript
n = 0 or 48: Select superscript
Subscript or superscript characters are printed at normal height. ESC S
remains in effect until ESC T is received. Multiple ESC S (n) commands
may be sent prior to an ESC T.
Note: This function works only if Sub/Superscript is enabled from the
configuration menu .
ESC T
ASCII: ESC T
Control: [ T
CTRL
Decimal: 27 84
Hexadecimal: 1B 54
Cancels subscript/superscript set by ESC S.
ESC 4
ASCII: ESC 4
Control: [ 4
CTRL
Decimal: 27 52
Hexadecimal: 1B 34
Allows most upright draft quality or NLQ style (condensed, bold, enlarged,
single/double strike) to be printed in italics.
Epson italic characters reside in the upper half of the Epson character
sets. ESC 4 causes this upper half to be mapped to the lower bytes.
ESC 5
(n)
(n)
(n)
(n)
Operator's Guide 215
Set Subscript/Superscript
Cancel Subscript/Superscript
Cancel Italics
Set Italics