Turning Off The Computer; Running The Setup Program - Epson Printer User Manual

If your system is configured to automatically start Microsoft
Windows or a word processing program, or has a different
operating system, you will see the first menu or screen of that
program displayed at this point. If your system is not
configured to start like this, you will see the MS-DOS operating
prompt, such as C:\ > or
computer.
Now follow the instructions below to configure your system
using the SETUP program.

Turning Off the Computer

Whenever you turn off your system, follow these steps
1.
Save your data and exit any application program you are
using.
2. Check the hard disk drive light and the diskette drive light(s)
to make sure they are not on. Do not turn off the computer
if a drive light is on, because you can damage the drive or
lose data.
3. Remove any diskette(s) from the diskette drive(s).
4.
Press the power button to turn off the computer and then
turn off the monitor, printer, and any other peripheral
devices.

Running the SETUP Program

to run SETUP the first time you use your computer, so
Be sure
you can verify or update the configuration information. You
also may need to run SETUP again later if you change your
configuration.
each time you turn on the
A: \>,
Setting Up Your System 1-9