Displaying System Information; Setting The Date And Time; Setting The Diskette Drive(S) - Epson Printer User Manual

Displaying System Information

When you press F2 from either of the SETUP screens, you will
see a list of the following:
Processor type
Coprocessor type (if one is installed)
Reserved memory
BIOS version number
Addresses for video mode, serial ports, and printer ports.
Press any key to return to the SETUP screen.

Setting the Date and Time

The real-time clock in your computer continuously tracks the
date and time-even when the computer is turned off. Once
you set the date and time using SETUP, you should not need to
change them, unless you adjust the time for daylight savings or
a different time zone. (The computer automatically changes the
date for leap years.)
Use
change. Then press + or – until you see the value you want.
Setting the Diskette
On your system, diskette drive A is the 3.5-inch, high-density
drive installed in the computer. You may also have another
drive of a different size or capacity; this is drive B. Check the
settings for both drives and correct them if necessary.
1-12 Setting Up Your System
or to move the cursor to the value you want to
Drive(s)