Grizzly G0701 Owner's Manual page 29

Note: If you choose, you can remove the two
lower cap screws and the upper hex bolt that
secure the blade guard, then have another
person hold the guard out of the way while
you adjust the upper blade guide and support
bearings.
Make sure to firmly secure the blade guard in
place when you have completed the adjust-
ment.
4.
5.
Figure 34
Figure 34.
6.
7.
Figures 32–33
8.
Note: With larger blades it may not be pos-
sible to reach the
adjust the bearings as far forward to the
blade gullets as possible.
Figure 35.
9.
Figure 36
Note: The goal is to position the support
bearing so it will support the blade when
pressure is applied during the cutting opera-
tion.
Figure 36.
Figure 35
1 ⁄ " spacing. In this case,
64