Loading Special Coated Paper And Transparencies - Epson PowerRIP Stylus User Manual

Loading Special Coated Paper and
Transparencies
Note:
Loading plain paper is described in Chapter 1.
1. Make sure the printable surface is face down. For coated
papers, the printable side is whiter than the other side.
For transparencies, the printable side is face down when
the cut corner is as shown below.
Caution:
c
Do not touch the printable surface; hold sheets by their
edges.
2. Insert the paper into the input tray until it meets resistance.
You can insert up to 70 sheets of coated paper or up to
50 transparencies.
3. Adjust the left and rear edge guides so that the paper or
transparencies feed straight into the paper path. Then
adjust the rear edge guide to match the length of your
paper.
Paper Handling
3-3