Table of Contents
Advertisement
If you are low on disk space and wish to specify what
components to install, choose one or more of the following:
AT-Stylus COLOR
Stylus COLOR
BI-D Calibration Utility
EPSON Monitor
EPSON Namer
You must install either the Stylus COLOR driver or the
AT-Stylus COLOR driver. The three utilities are optional. If
you do not install these utilities on your hard disk, you can
run them from the diskette drive when needed.
4. Click Install to copy the software to your hard disk.
5. When installation is complete, choose Quit to quit the
installer.
6. Restart your Macintosh.
7. If you installed the AT-Stylus driver, you need to assign
a name to the printer using the EPSON Namer utility. See
Appendix A for more information.
This driver allows you to use
the optional LocalTalk interface
to connect the printer to an
AppleTalk network.
This driver allows you to use
the serial interface to connect the
printer directly to the Macintosh.
This utility calibrates the printer
so vertical lines are aligned.
This utility monitors and manages
print jobs that have been sent to
the printer. For more information,
see "Using the EPSON Monitor
Utility to Manage Print Jobs" in
Chapter 2.
This utility assigns a unique name
to the printer.
Setting Up the Printer
1-15
Advertisement
Table of Contents
