Three-Button Primax Mouse; Logitech Wheel Mouse; Resetting A Hung Ism Card - Intergraph InterServe 8000 Supplementary Manual

2
4. Do one of the following, as appropriate:
Change the value to Enabled to limit memory use to 2 GB.
Change the value to Disabled to use all of the system's memory.
5. Save the change and exit from BIOS Setup.
6. Restart the system.
You can also reset the BIOS to Optimal to use all of the system's memory. See the System
Setup document delivered with the system for more information on the system's BIOS.
NOTE The System Properties dialog (under Start/Settings/Control Panel/System) shows only 2 GB of
memory on systems with more than 2 GB of memory enabled. To verify the correct amount of
memory, check the Memory tab of the Windows NT Diagnostics dialog (under
Start/Programs/Administrative Tools).

Three-Button Primax Mouse

If your system was delivered with a three-button Primax mouse, you may see a message that
says "MouseWare has detected a new Wheel Mouse...." and asks if you want to configure the
new device. If this happens, select No. If you experience any other anomalies while using the
Primax mouse, reinstall the mouse driver found on the Windows NT software CD-ROM.

Logitech Wheel Mouse

If your system was delivered with a Logitech wheel mouse, you can find information on using
it by right-clicking the mouse icon in the taskbar tray, or by going to Start/Settings/Control
Panel/Mouse and clicking Help in the toolbar.
If the wheel on the mouse does not function, or if you experience any other anomalies while
using the wheel mouse, install the
using InterSite Version Manager.

Resetting a Hung ISM Card

An InterSite Server Monitor (ISM) card (also called Server Monitor Module [SMM] or
Emergency Management Card [EMC]) in an InterServe 8000 may hang if system power is
turned off, then on again quickly, using the system's keyswitch.
driver software from the Intergraph System CD
LMOUSE