Table of Contents
Advertisement
Connecting the Battery Pack
Unlock the rear cover by pressing down on the spring lock at the
top of the cover. Remove the cover. For shipment from the factory,
the battery is left out of the MX-890. Place the battery into the
battery compartment, making sure you align the contacts on the
battery to the contacts on the MX-890. The battery will snap into
place when aligned properly. Replace the cover and snap it into
place.
Using the Charging Base
Plug the 5V adapter into a power outlet and into
the back of the charging base.
Gently place the MX-890 into the cradle of the
charging base. It automatically aligns itself
to the contacts on the charging base.
The Status light should immediately light. Red
indicates that it is charging. Blue shows that it
is fully charged. There is no harm in leaving
the MX-890 on its charging base whenever
it is not in use.
Optionally, the 5V power adapter can be plugged
directly to the bottom of the MX-890.
Resetting the MX-890
Normally, resetting the MX-890 is not necessary. However, if you
notice unusual behavior, press the reset button within the battery
compartment. Press the Reset button to cycle the MX-890's power
and reboot the unit.
MX-890 C
LCD S
OLOR
Page 3
CREEN
Red indicates charging, Blue that
the remote is fully charged.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the MX-890 and is the answer not in the manual?
Questions and answers
MX-890 remote works intermittently when NOT in the cradle. I need to put it in the cradle to get it to work after removing it and placing it back into the cradle a few times. Battery has been replaced. Reads full power.
The MX-890 may work intermittently when not in the cradle due to a low battery. Ensure the remote is fully charged by placing it in the charging base until the status light turns blue. If issues persist, try resetting the remote by pressing the reset button within the battery compartment.
This answer is automatically generated
The light on the screen is just white with some gray out boxes. I don’t know how to reset and I’m afraid I will lose the programmed items in the remote.
cannot locate reset button in the battery compartment