Table of Contents
Advertisement
Federal Communication Commission
Interference Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installa-
tion. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one more of the follow-
ing measures:
u
Reorient or relocate the receiving antenna.
u
Increase the separation between the equipment and receiver.
u
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
u
Consult the dealer or an experienced radio/TV technician for
help.
Warning!
Changes or modifications not expressly approved by the manufacturer could
void the user's authority to operate the equipment.
Note : The manufacturer is not responsible for any Radio or TV interference
caused by unauthorized modifications to this equipment. Such modifications
could void the user's authority to operate the equipment.
FCC Caution
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the authority to operate equipment.
MX-890 C
LCD S
OLOR
Page 11
CREEN
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the MX-890 and is the answer not in the manual?
Questions and answers
MX-890 remote works intermittently when NOT in the cradle. I need to put it in the cradle to get it to work after removing it and placing it back into the cradle a few times. Battery has been replaced. Reads full power.
The MX-890 may work intermittently when not in the cradle due to a low battery. Ensure the remote is fully charged by placing it in the charging base until the status light turns blue. If issues persist, try resetting the remote by pressing the reset button within the battery compartment.
This answer is automatically generated
The light on the screen is just white with some gray out boxes. I don’t know how to reset and I’m afraid I will lose the programmed items in the remote.
cannot locate reset button in the battery compartment