Set Array - Qlogic MPX200 User Manual

set array

Sets the target type of an array to make it behave as either a source, a
destination, or both.
Authority
miguser
Examples
The following example shows the set array command:
iSR6200 <1> (miguser) #> set array
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Index WWPN, PortId/ iScsiName, Ip Add
----- ---------------------------------
0 50:00:1f:e1:50:0a:e1:49, 8c-02-00
1 50:00:1f:e1:50:0a:37:18, 82-04-00
2 50:06:01:62:41:e0:49:2e, 82-01-00
3 iqn.2001-05.com., 30.30.30.2
4 iqn.2001-05.com., 30.30.30.2
5 50:0a:09:82:88:8c:a7:79, 61-12-00
Please select a Target Id from the list above ('q' to quit):
Symbolic Name (Max = 128 characters)
Target Type (1=SrcTarget, 2=DstTarget, 3=Src+Dest 4=None Target)
Bandwidth for Migration (0=Array Bandwidth, 50-1600 MBps )
Enable Load Balancing (0=Enable, 1=Disable)
Do you want to apply Local Migration Array license (yes/no)
Do you want to apply Data Scrubbing Array License (yes/no)
LunInfo Display with (1=LunId, 2=WWULN, 3=Serial Number)
All attribute values for that have been changed will now be saved.
Follow these steps to change the array properties using the CLI. Note that all data
migration operations are authorized only to the migration administrator session,
miguser. For more information, see
To set array properties in the CLI:
1. Log in to the iSR6200 as guest and enter the password.
2. Open a miguser session using the following command:
miguser start -p migration
ISR654608-00 C
6–Command Line Interface
Symbolic Name
--------------------
HP HSV200-0
HP HSV210-2
DGC RAID-2
EQLOGIC 100E-00-7
EQLOGIC 100E-00-8
NETAPP LUN-3
"Miguser Session" on page
set array
Target Type
------------
Src+Dest
Src+Dest
Src+Dest
Src+Dest
Src+Dest
Unknown
5
[NETAPP LUN-3]
[3 ]
[0 ]
[Enabled ]
[No ]
[No ]
[1 ]
6-2.
6-61