Floppy Disk Controller - TYAN Toledo q35T User Manual

3.4.3 I/O Device Configuration
This setting allows you to configure I/O devices.
Main

Floppy disk controller

Serial port A:
Base I/O address:
Interrupt:
Serial port B:
Mode
Base I/O address
Interrupt:
F1 Help
Esc Exit
← →
Floppy disk Controller
This defines how the floppy disk controller is detected and configured.
Options: Disabled / Enabled / Auto
Serial Port A/B:
This defines how the serial port A/B is detected and configured.
Options: Disabled / Enabled / Auto
Base I/O Address:
Set the base I/O address for serial port A/B.
Options: 3F8 / 2F8 / 3E8 / 2E8
Interrupt:
Set the interrupt for serial port A/B.
Options: IRQ3 / IRQ4
Mode
Set the mode for serial port B.
Options: IR / Normal
PhoenixBIOS Setup Utility
Advanced
I/O Device Configuration
Select Item
↑↓
Select Menu
Security Power
[Enabled]
[Enabled]
[3F8]
[IRQ4]
[Enabled]
[Normal]
[2F8]
[IRQ3]
-/+ Change Values
Enter Select
Sub-Menu
52
Boot Exit
Item Specific Help
Configure using these
options:
[Disabled] No
configuration
[Enabled] User
configuration
[Auto] BIOS or OS
chooses configuration
(OS Controlled)
Displayed when
controlled by OS
F9 Setup Defaults
F10 Previous Values