Epson EPL-8000 User Manual page 153

SAVE MEMORY OVERLOW
[E]
This message may appear when you are trying to save a
macro with the SAVE MACRO option. The printer does not
have enough memory to save the macro. To correct this error,
delete unused macros using the DELETE MACRO option.
SERVICE REQ. CXXXX
[E]
A controller error has been detected. Write down the error
number listed on the display and turn off the printer. Wait at
least five seconds and then turn it back on. If the error
message still appears, turn off the printer, unplug the power
cord, and contact a qualified service person.
SERVICE REQ. E00XX
[E]
A print engine error has been detected. Write down the error
number listed on the display and turn off the printer. Wait at
least five seconds and then turn it back on. If the error
message still appears, turn off the printer, unplug the power
cord, and contact a qualified service person.
SET FULL PRINT
[E]
This message may appear when you are trying to print
graphics or a mix of text and graphics. Press CONTINUE and
then change the SelecType FULL PRINT setting as described
in Chapter 3.
[W]
SET MANUAL
There is no paper in the manual feed tray and you have
selected manual feed. Load a sheet of paper in the manual
feed tray. To cancel manual feed, press the MANUAL button
to feed paper from the paper cassette. This message alternates
with CANCEL MANUAL FEED.
[S]
STANDBY MODE
If all of the channels receive no data for about thirty minutes
and the STANDBY mode is enabled in SelecType, the printer
enters standby mode. Press any panel button or send data to
warm up the printer,
Status and Error Messages
Troubleshooting 6-7