Installing The Software - Brother PE-DESIGN PLUS Operation Manual

Before Use

Installing the Software

This section describes how to install the application
software.
a
Note:
• If the installation is interrupted or not
performed as described, the software
will not be installed correctly.
• Before turning on the computer, be sure
that the USB Card Writer Module is
DISCONNECTED.
• In order to install the software, you must
log on to the computer using an account
with administrator privileges. If you are
not logged on with the Administrator
account, the password for the
Administrator account (Administrators)
may be requested with Windows
Type in the password to continue the
procedure.
1.
Insert the enclosed CD-ROM into the
computer's CD-ROM drive.
6
■
Windows
 After a short while, the language selection
b
If the installer does not automatically start
up:
1) Click the Start button.
2) Click Run.
3) Type in the full path to the installer, and
■
For Windows
Vista
®
7.
 After a short while, the AutoPlay dialog
b
If the AutoPlay Dialog does not automatically
start up:
1) Click the Start button.
2) Click All Programs  Accessories 
3) Type in the full path to the installer, and
®
XP users only
dialog box for InstallShield Wizard
automatically appears.
4.
Continue with step
Memo:
 The Run dialog box appears.
then click OK to start up the installer.
For example: F:\setup.exe (where "F:" is
the name of the CD-ROM drive)
®
7 or Windows
®
users:
box automatically appears.
Memo:
Run.
 The Run dialog box appears.
then click OK to start up the installer.
For example: F:\setup.exe (where "F:" is
the name of the CD-ROM drive)
on page 7.