Golden Technologies Companion I GC240 Owner's Manual page 17

Companion Owner's Manual: GC240, GC340, GC440
Armrest Width Adjustment
To adjust the armrest width:
1. Loosen the adjustment knobs at the
rear of the seat. See figure 6.
2. Slide the armrests in or out to the
desired width. See figure 7.
3. Tighten the adjustment knobs.
Seat Height Adjustment
To adjust the seat height:
1. Remove the seat by raising the lever
and lifting the seat straight up.
2. Set the seat aside.
3. Remove the bolt, nut, and washer that
hold the seat post in the seat pedestal.
See figure 8.
4. Position the seat post at the desired
height while aligning the holes in the
seat post and the seat pedestal.
5. Reinstall and tighten the nut, bolt,
and washer. The bolt must be installed
from the back of the pedestal, with the
nut and washer to the front of the
scooter.
6. Raise the lever when placing the seat
back on the seat post.
Seat Rotation Lever
The seat can be rotated through 360° and
locked at any 45° position.
1. Pull up on the seat rotatation lever
and rotate the seat to the desired
position. See figure 4.
2. Release the handle to lock the seat at
any 45° position.
Flip-up Armrests
Pull up on the end of either armrest to flip
it up for easy transfer on and off your
Golden Companion. See figure 9.
Armrest Angle
To increase the armrest angle, turn the
armrest angle screw clockwise. See figure
6. To decrease the armrest angle, turn the
armrest angle screw counterclockwise.
Companion
V. OPERATION
ARMREST ADJUSTMENT
KNOBS
FIGURE 6. ARMREST ADJUSTMENTS
FIGURE 7. ARMREST WIDTH
FIGURE 8. SEAT HEIGHT
FIGURE 9. FLIP-UP ARMRESTS
ARMREST ANGLE
ADJUSTMENT
17