Advertisement
(G-7)
POWER
2
3
COUNTER RESET
5
6
7
ZEROMEM
STBY
- 0:00:20
START!
STOP
(G-7)
1
While pressing the green button, set
POWER to CAMERA.
2
Slide STANDBY up to set the camcorder to
standby mode.
3
While looking in the viewfinder, keep
pressing the + or - side of EDITSEARCH
and release the button where you want to
end the insertion.
The camcorder is set to standby mode again.
4
Press COUNTER RESET.
The counteris resetto zero.
5
While looking in the viewfinder, keep
pressing the - side of EDITSEARCH
and
release the button at the point where you
want to start the insertion.
6
Press ZERO MEM.
The insert ending point is stored in memory.
7
Press START/STOP.
A beep sounds and insert recording begins.
Then the recording stops automatically near
the counter zero point.
To cancel the ZERO MEM
Press ZERO MEM.
Note
The picture may be distorted at the end of the inserted
portion when it is played back.
26
Advertisement
