Using Appletalk Under Windows 2000 Or Nt 4.0 - Epson C2600/2600 Owner's Manual

Note:
❏ You need an optional Hard Disk Drive installed in your printer in
order to use the Reserve Job function. Make sure that the drive is
correctly recognized by the printer driver before you start using the
Reserve Job function.
❏ The Reserve Job function cannot be used when you are printing
using the AppleTalk protocol in Windows 2000 or NT 4.0.
❏ Make sure to clear the Job Management On check box on the Job
Settings sheet when outputting data as a PS file. The Job
Management check box is selected by default so that the job
information is attached to the print data when it is sent to the printer.
Follow the steps below to use the Reserve Job function when
printing from any application.
1. Click Print from the application's File menu.
2. Click Properties, then click the Job Settings tab.
3. Specify the desired Reserve Job settings in the dialog box that
appears.
4. When printing multiple copies, select the Collated check box
in the Advanced settings of the printer driver.
5. When you are done with the settings, then click Print.

Using AppleTalk under Windows 2000 or NT 4.0

Use the following settings if your machine is running Windows
2000 or NT 4.0, and the printer is connected through an network
interface using the AppleTalk protocol:
❏ Use SelecType to set the Emulation Mode-Network item to
PS3. Using the default Auto setting will cause an extra,
unneeded page to be printed.
Using the PostScript Printer Driver
6
6
6
6
6
6
6
6
6
6
6
6
213