Table of Contents
Advertisement
6. Reattach the cover to the back side of the printer and secure
it with the four screws.
7. Reconnect the power cord and turn the printer on.
To confirm that the option is installed correctly, print a Status
Sheet. See "Printing a Status Sheet" on page 370.
If P5C is not listed as an installed emulation on the status sheet,
try reinstalling the module. Make sure that it is securely seated
into the ROM slot on the circuit board.
Removing the P5C ROM module
Caution:
c
Before you remove the ROM module, be sure to discharge any
static electricity by touching a grounded piece of metal.
Otherwise, you may damage static-sensitive components.
Warning:
w
Be careful when working inside the printer as some components
are sharp and may cause injury.
Turn off the printer and perform the installation procedure in
reverse.
312
Installing Options
Advertisement
Table of Contents
