Configuring For Netbeui - Epson Stylus Color 900N User Manual

4. Click the
message "Configuration is successfully done" appears, the update is complete.

Configuring for NetBEUI

You can use NetBEUI in Windows networks to print to your EPSON Stylus
COLOR 900N. Configure the card for NetBEUI using the card's internal home
page.
Before you can configure the card for NetBEUI, you must:
Set up TCP/IP on all the workstations that will use the printer.
Set the IP address for your Ethernet card (see page 39).
Make sure you have either Microsoft Internet Explorer 4.0 or later, or Netscape
Navigator 3.0 or later.
Then, follow these steps to access the Ethernet card home page and configure the
card:
1. Run EPSON Net!2. Click the printer you want to configure from the list, and
click the
Or, run the browser and type the IP address for the Ethernet card. Do not run
EPSON Net!2 while the browser is running.
Type the following URL:
http:// (IP address of the Ethernet card) /
The home page appears.
46
button to save the new settings to the Ethernet card. If the
Send
EPSON Net!2 for Windows and the Ethernet card home page
can't be open at the same time.
If you have not assigned an IP address to the Ethernet card, or if
you use the default setting (including when you select DHCP to
acquire an IP address), you can't configure the Ethernet card for
NetBEUI using the Ethernet card home page.
button. EPSON Net!2 closes automatically.
Launch Browser