Vendor Coupon; Store Coupon - TEC MA-1350-1 SERIES Owner's Manual

NOTES: 1. For entering a Dollar Discount that will cause the sale total into negative (credit balance), one
of the following can be selected (ask your TOSHIBA TEC representative):
If status "Credit Balance Prohibited" (initial status) is selected:
If status "Credit Balance Allowed" is selected:
2. The [DOLL DISC] key has its own Tax (PST) Status, GST Status, and Food Stamp Status
programmed. Refer to "Tax Status Modification" (page 40) and "Food Stamp Modifica-
tion" (page 41) for reversing the status.
3. Dollar Discount can be programmed to require the MGR position of the Control Lock. If so
programmed, an error will occur on depressing the [DOLL DISC] key in the REG position. In
this case, ask the store manager to turn the Control Lock to the MGR position for the entry.
(Refer to the chapter 1. Operations in "MGR" Mode on page 1 in Manager's Guide.)

Vendor Coupon

Sale Item Entries
NOTES: 1. For entering a Vendor Coupon amount that will cause the sale total into negative (Credit
Balance), one of the following can be selected (ask your TOSHIBA TEC representative):
If status "Credit Balance Prohibited" (initial status) is selected:
If status "Credit Balance Allowed" is selected:
2. The [VND CPN] key has its own Tax (PST) Status, GST Status, and Food Stamp Status
programmed. Refer to "Tax Status Modification" (page 40) and "Food Stamp Modifica-
tion" (page 41) for reversing the status.
3. Vendor Coupon Entry can be programmed to require the MGR position of the Control Lock. If
so programmed, an error will occur on depressing the [VND CPN] key in the REG position. In
this case, ask the store manager to turn the Control Lock to the MGR position for the entry.
(Refer to the chapter 1. Operations in "MGR" Mode on page 1 in Manager's Guide.)
4. When a limit amount has been programmed for the [VND CPN] key, an amount exceeding
the limit amount cannot be entered in the REG position. However, in the MGR or - position,
the limit amount programmed is ignored and max. 7-digit amount can be entered through the
[VND CPN] key.

Store Coupon

STR
Depress prior to or any time during the entry sequence of the following operations for Open-price
CPN
or Preset-price Departments already described:
NOTES: 1. The [STR CPN] key must be pressed, at the latest, before the final key of the required
Department entry sequence.
2. The Store Coupon amount must be entered inside a sale and must not exceed the sale total
unless the "Credit Balance Allowed" option is selected. (Ask your TOSHIBA TEC representative.)
3. Quantity Extension (multiplication) is permitted with this key, but no decimal quantity will be
accepted.
Over-subtraction of the sale total by Dollar Discount causes an error.
Over-subtraction of the sale total by Dollar Discount is possible.
( )
ST
Vendor Coupon
Over-subtraction of the sale total by Vendor Coupon causes an error.
Over-subtraction of the sale total by Vendor Coupon is possible.
Entry of One Department Item
Department Quantity Extension
Single-item Department Entry
VND
. . .
CPN
Amount
NOTE 3
NOTE 2
- 31 -
MA-1350-1 SERIES
V.CPN 1.00-
An amount of $1.00 is en-
tered as Vendor Coupon.
EO1-11126