Display; Numeric Display - TEC MA-1350-1 SERIES Owner's Manual

6. Display

The Operator's Display (front display) is located at the top of the register just above the keyboard. The
Customer's Display may be used only as a rear display if left in the retracted position or it can be positioned for
viewing at other angles by pulling it upward and turning it to the desired position. The display has two types of
display portions—numeric display and message descriptors (status lamps).

Numeric Display

AMOUNT (10 digits for total display, 7 digits for entries):
Displays the numeric data, such as amount, quantity, etc. When the obtained total or
subtotal amount is 10-digit value, the RPT and DPT digits are also used for the amount
display. When no entries are under way and the Control Lock is in the REG position, the
current time is displayed.
DPT (2 digits): Displays the code which represents each Department key. It stays lit when repeating the
same department entry.
RPT (1 digit): Displays the repeat count of the same item. The count is indicated from the second entry
on, and only the last digit will be displayed even if the count exceeds nine.
PLU (3 digits of the DPT and RPT are used for this purpose):
Displays the PLU code when any PLU is entered. It goes out when repeating the same
PLU entry, then only the RPT digit will be displayed for the repeat entry count. When a
sale item of PLU code 1000 or more is entered, only the lowest 3 digits in the 4-digit code
will be displayed.
CLERK (1 digit): Displays a cashier code instead of a department code by the program option. (Ask your
TOSHIBA TEC representative.)
PRICE (1 digit): Displays PLU price shift No. instead of a department code by the program option. (Ask
your TOSHIBA TEC representative.)
Operator's Display
PLU
DPT RPT
PC SLIP R ALM
OFF
I I
CLERK PRICE
Customer's Display
AMOUNT
SIGN TL
ON
AMOUNT
AMOUNT
TL ST CG
- 5 -
ST CG
EO1-11126
MA-1350-1 SERIES