Epson 300 User Manual page 68

Paper does not fully eject.
Cause
The paper is too long.
Paper feed or paper jam problems occur frequently.
Cause
Sheets of paper are stuck
together.
The edge guides are not set
correctly.
The paper is too thin or
rough.
Special media that should be
loaded one sheet at a time is
loaded more than one sheet
at a time.
Too many sheets are loaded
in the sheet feeder.
The printable side of the
paper is not loaded correctly.
6-14
Troubleshooting
What to do
E
Press the load/eject button to eject
the paper. Use paper that meets the
paper requirements for this printer.
See "Paper" in the Appendix.
What to do
Fan the stack of paper and straighten it
before loading.
Adjust the guides against the stack of
paper.
Make sure the paper meets the paper
requirements for this printer. See
"Paper" in the Appendix.
Check the loading capacity for special
media described on pages 4-4 and 4-5.
Load paper only up to the arrow mark
on the left edge guide.
Try turning the stack of paper over in
the sheet feeder. Most packages of
paper indicate the printable side with
an arrow on the end of the package.
Make sure the printable side is loaded
face up.