Functional Description - Delta 22-681 Instruction Manual

15" planer

Hide thumbs

Table Of Contents

Table of Contents

THREE PHASE OPERATION

Three phase MACHINES are not supplied with a power

cord. They must be permanently connected to the

building electrical system and grounded according to

the National Electrical Code. Since they must be

permanently connected to the building electrical

system, extension cords cannot be used with three

phase MACHINES.

200-220 VOLT, THREE PHASE

OPERATION

If the motor on your machine is wired for 200-220 Volt,

Three Phase operation, proceed as follows when con-

necting your planer to an electrical power system:

1. Remove the two screws that attach the switch

cover (A) Fig. B, to the switch box and remove the

switch cover (A).

2. Remove lower right knockout from bottom of

switch box (B) Fig. C, and assemble a strain relief

(not supplied) in its place.

3. Bring the three phase power line up through the

strain relief, and connect the three power lines to

terminals L1, L2 and L3, shown at (C) Fig. C, and

connect the green ground wire to ground screw (D).

4. IMPORTANT: IF AFTER THE MACHINE IS IN

OPERATION THE CUTTERHEAD REVOLVES IN

THE WRONG ROTATION, INTERCHANGE ANY

TWO OF THE THREE POWER LINES THAT ARE

CONNECTED TO TERMINALS (C) FIG. C.

5. Replace switch cover that was removed in STEP 1.

EXTENSION CORDS

Use proper extension cords. Make sure

your extension cord is in good condition and is a 3-wire

extension cord which has a 3-prong grounding type

plug and matching receptacle which will accept the

machine's plug. When using an extension cord, be sure

to use one heavy enough to carry the current of the

machine. An undersized cord will cause a drop in line

voltage, resulting in loss of power and overheating. Fig.

D shows the correct gauge to use depending on the

cord length. If in doubt, use the next heavier gauge. The

smaller the gauge number, the heavier the cord.

FOREWORD

Delta Model 22-680 is a 15" (381mm) Planer with adjustable feed rate for optimum planing under load. It has the

following cutting capacities; 15" (381mm) width, 6½" (165mm) thickness and 1/8" (5mm) depth of cut.

NOTICE: THE PHOTO ON THE MANUAL COVER ILLUSTRATES THE

CURRENT PRODUCTION MODEL. ALL OTHER ILLUSTRATIONS CONTAINED

IN THE MANUAL ARE REPRESENTATIVE ONLY AND MAY NOT DEPICT THE

ACTUAL COLOR, LABELING OR ACCESSORIES AND ARE INTENDED TO

ILLUSTRATE TECHNIQUE ONLY.