Functional Description; Carton Contents - Delta 22-785 Instruction Manual

EXTENSION CORDS
Use proper extension cords. Make sure
your extension cord is in good condition and is a 3-wire
extension cord which has a 3-prong grounding type
plug and matching receptacle which will accept the
machine's plug. When using an extension cord, be sure
to use one heavy enough to carry the current of the
machine. An undersized cord will cause a drop in line
voltage, resulting in loss of power and overheating. Fig.
D-1, shows the correct gauge to use depending on the
cord length. If in doubt, use the next heavier gauge. The
smaller the gauge number, the heavier the cord.
FOREWORD
Delta Models 22-785 and 22-785X are 15" (381mm) Planers with adjustable feed rate for optimum planing under load.
They have the following cutting capacities; 15" (381mm) width, 6½" (165mm) thickness and 1/8" (5mm) depth of cut.
NOTICE: The photo on the manual cover illustarates the current production model. All other illustrations contained in
the manual are representative only and may not depict the actual labeling or accessories included. These are are
intended to illustrate technique only.
Your new 15" Planer is shipped complete in one box.
The machine is very heavy. Care must be taken when
removing the machine. (See the section "LIFTING THE
MACHINE").
Figure 3 Illustrates the loose items supplied with your
machine.

FUNCTIONAL DESCRIPTION

CARTON CONTENTS

MINIMUM GAUGE EXTENSION CORD
RECOMMENDED SIZES FOR USE WITH STATIONARY ELECTRIC MACHINES
Ampere
Rating Volts
0-6 240
0-6 240
0-6 240
0-6 240
6-10 240
6-10 240
6-10 240
6-10 240
10-12 240
10-12 240
10-12 240
10-12 240
12-16 240
12-16 240
12-16 240
7
Total Length Gauge of
of Cord in Feet Extension Cord
up to 50 18 AWG
50-100 16 AWG
100-200 16 AWG
200-300 14 AWG
up to 50 18 AWG
50-100 16 AWG
100-200 14 AWG
200-300 12 AWG
up to 50 16 AWG
50-100 16 AWG
100-200 14 AWG
200-300 12 AWG
up to 50 14 AWG
50-100 12 AWG
GREATER THAN 100 FEET NOT RECOMMENDED
Fig. D-1
Fig. 2