About The Encode + Decode Demo - Texas Instruments TMS320DM6446 DVEVM v2.0 Getting Started Manual

Running the Standalone Demos
3.3.2

About the Encode + Decode Demo

3-6
The Encode + Decode demo allows you to record and playback video.
Video comes from the camera, is encoded, then decoded, and then sent
to the LDC display.
The Encode + Decode does only video processing; it does not encode
and decode audio or speech. The supported video algorithm is H.264
Baseline Profile (.264 file extension).
Table 3–1 IR Remote Buttons for Encode + Decode Demo
IR Remote Button Mode
Up/Down --
Play or OK Setup
Record --
Info/Select Setup
Info/Select Run
Left/Right Run
Pause Run
Stop Setup / Run
The application runs on the ARM using Linux. The video signal is passed
to video encoders and decoders on the DSP by the Codec Engine.
Shared memory is used when passing data.
To use this demo from the command line, see Section 3.4, Running the
Demos from the Command Line.
Action Performed
-- no action --
Begin demo
-- no action --
Show / hide block diagram for demo
Toggle information display
Change information transparency level
Pause demo (press Play to resume)
Return to previous screen