When Choosing A Place For The Printer - Epson Stylus Photo 925 User Manual

If you use an extension cord with the printer, make sure that
the total ampere rating of the devices plugged into the
extension cord does not exceed the cord's ampere rating. Also,
make sure that the total ampere rating of all devices plugged
into the wall outlet does not exceed the wall outlet's ampere
rating.
Do not attempt to service the printer yourself.
Unplug the printer and refer servicing to qualified service
personnel under the following conditions:
The power cord or plug is damaged; liquid has entered the
printer; the printer has been dropped or the cabinet damaged;
the printer does not operate normally or exhibits a distinct
change in performance.
If you plan to use the printer in Germany, the building
installation must be protected by a 10 or 16 amp circuit
breaker to provide adequate short-circuit protection and
over-current protection for this printer.

When choosing a place for the printer

Observe the following when choosing a place for the printer:
Place the printer on a flat, stable surface that extends beyond
the printer base in all directions. If you place the printer by
the wall, leave more than 10 cm between the back of the
printer and the wall. The printer will not operate properly if
it is tilted at an angle.
When storing or transporting the printer, don't tilt it, stand it
on its side or turn it upside down. Otherwise ink may leak
from the cartridge.
Leave enough space in front of the printer for the paper to be
fully ejected.
5