Preparing A Hard Disk For Use - Epson Equity Ie Q50188015-1 User Manual

Equity ie user manual
Table of Contents

Advertisement

Chapter 2

Preparing a Hard Disk for Use

If your computer has a hard disk, follow the instructions in this chapter to
prepare it before using it for the first time.
WARNING
Do not perform any of these procedures if your hard disk has already been
prepared for use or has data stored on it; otherwise, you will erase all the
data on the hard disk. These instructions apply only to a new hard disk.
The hard disk inside your computer has a capacity of 20 megabytes-about
20 million characters. This is equivalent to approximately 30 720KB
diskettes. Using a hard disk reduces the number of diskettes you need
and eliminates much of the diskette-swapping you do when you use
diskettes. You can do almost all your work on the hard disk and copy
your files to diskettes as needed (to make backups, for example).
Although the hard disk is very reliable, it is essential to back up any of
your hard disk files that you cannot afford to lose. Use the Epson MENU
program or the MS-DOS BACKUP command described in your MS-DOS
manual to back up your hard disk files.
Before you can use the hard disk, you must do the following things to
prepare it:
Use the FDISK program to partition the hard disk to run the MS-DOS
l
operating system.
Use the SELECT program to format the MS-DOS partition and to
l
copy the MS-DOS Startup/Operating 1 files to the hard disk.
Use the COPY command to copy files from the Operating 2 and
l
Reference diskettes to the hard disk.
These procedures are described in this chapter.
Preparing a Hard Disk for Use
2-1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Equity ie

Table of Contents