Table of Contents
Advertisement
Moving the Cursor Block
Use 1 and 1' to move the cursor block (the highlighted bar)
through the options on the main Setup menu. After you
highlight the option you want, press [Enter to select it.
Note
If the arrow keys on the numeric keypad do not appear to
work, num lock mode may be enabled (turned on). If the
Num Lock
is lit, press 1-1 once to turn it off and enable the arrow
keys on the numeric keypad. If you need to enter numbers
while using the Setup program and you want to use the
numeric keypad, press [G] to turn it back on.
Follow the instructions in the rest of this chapter to use the
Setup program to define your computer's configuration.
Setting the Display Adapter Type
The Setup program can usually detect the exact type of display
adapter you are using with your computer. If you have
connected a VGA monitor to the built-in VGA port, the Setup
program automatically sets the display adapter type. (With
this option you select the type of display adapter you are
using-not the type of monitor.) If you have installed a display
adapter card-or you just want to check the display adapter
setting-follow these steps.
2 - 6
Running the Setup Program
indicator in the upper right corner of the keyboard
Advertisement
Table of Contents
