Epson 486SX User Manual page 63

Follow these steps to change your built-in serial and parallel
interface settings:
1. At the main menu, highlight Serial/Parallel. The
current settings for each port appear:
S e r i a l
P a r a l l e l
Press m to move the cursor block into the submenu.
2.
You see this additional option menu:
Disabled
Primary
Secondary
If you want to change
3.
Serial is highlighted and press IEnter If you want to
change the parallel port setting, highlight Parallel and
press [Enter. The cursor block moves into the submenu.
Use L or 1' to highlight the appropriate setting for the port
4.
you selected and press IEnter The screen displays the new
setting.
Note
If you add an option card with a parallel or serial port
and highlight
your built-in port and the port on the option card, you
see this message:
C o n f l i c t w i t h o p t i o n c a r d
Primary
Primary
serial port setting, be sure
the
causes a conflict between
a setting that
Running the Setup Program
2-29