Epson 486SX User Manual page 135

Grasp the front of the drive and pull it out.
3.
Note
If you remove an IDE hard disk drive from the external
bay and it is your only hard disk drive, you must also
remove the hard disk drive cable from its connector on
the main system board. First remove the cable from the
clasp on the left side of the subassembly. Then
disconnect the cable from the main system board.
If the drive you removed was accessible from the front of
4.
the computer, you need to reinstall the front panel slot
cover for that drive.
Turn the front panel so you are facing the inside. Then press
the slot cover into the slot until it snaps into place between
the tabs on both sides.
Replace the computer's front panel and cover as
5.
described in Chapter 5; then see "Post-installation Setup"
on page 5-12 to update your configuration.
Installing and Removing Drives 7-13